TIC Speaker GS10 User Manual

Outdoor Omni Speaker Models  
GS3/ GS5/ GS5L/ GS7/ GS10  
TIC Outdoor OmniSpeakers Feature  
Weatherproof Design  
True 360° Sound  
In-ground or surface mount  
Full range 100W or 200W speaker  
drivers (model dependent)  
5”-8” co-axial drivers  
1” aluminum tweeters  
Surge protected Revchem®  
Teflon® sealed  
8 Ohm Impedance  
70v optional for Commercial  
Installations  
1m 14/2 Dbl. Insulated tail  
ABS Impact Resistant Formulated  
Enclosure  
Aesthetically, unobtrusive shrub  
green finish  
©TIC Corporation U.S.A.  
 
Index…  
Introduction ………………….……………  
Component List …………………….…….  
Pre-Installation …………………… ……..  
Connection Cable ……… ……………....  
3
4
4
5
Exterior Installation ……………………… 5/6  
Maintenance ………………………………  
Customer Service ………………..………  
Warranty …………………………..………  
Trouble Shooting ……...…………….…...  
7
7
7
9
Technical Specifications …………….….. 10  
Thank You for purchasing another high quality audio  
product from TIC Corporation. Please read the enclosed  
installation guidelines carefully and thoroughly to ensure  
years of trouble free service from your new TIC exterior  
audio products.  
Carefully unpack your new TIC exterior product and  
save all packaging materials for possible future use. Check  
that your new TIC product contains all system parts  
detailed in the Components list. Do not attempt to operate,  
install or use your new TIC product if any components  
appear missing or damaged. If so, please notify TIC  
Corporation or your TIC Dealer as soon as possible.  
!WARNING! to avoid possible suffocation or injury please  
keep all plastic bags away from children and pets.  
 
Component List…  
1x (GS3, GS7L)  
2x (GS5, GS5L, GS10)  
Outdoor Omni Speakers  
1M 14/2 cable tail  
1x (GS3, GS7L)  
2x (GS5, GS5L, GS10) 30ft. cable  
New product offer (enclosed  
with literature)  
1x  
1x  
1x  
Instruction Manual  
Warranty Card  
Pre-Installation…  
Need Professional Help?  
Please read this owners guide carefully before installation. Failure to follow  
these instructions fully or incorrect installation may damage your new TIC  
products and any third party equipment used in your new system installation.  
This may also Void any warranty for your new TIC products. If you are unsure  
of your ability to fully understand and fully complete the installation of this TIC  
product, please consult a professional installer.  
Note: TIC Corporation always recommends that you test your product and its  
components prior to exterior installation. Test your components near a mains  
power and, if required, receiver amplifier source somewhere convenient,  
perhaps inside. Ensure all components are working smoothly and correctly  
before exterior placement and operation.  
Exterior Installation…  
 
Before you begin the installation of your new TIC outdoor product, please  
carefully select the locations of your new TIC products.  
In general;  
1. Select a reasonably level surface for the installation of your new TIC  
outdoor speakers. For surface speakers this will prevent movement or  
excessive vibration during use. This will also ensure more uniform  
sound dispersion.  
2. Ensure your new TIC outdoor speaker cables or power source if  
required, can easily reach your new speakers. Some people even pre-  
lay string as a guide ensuring that there are no obstructions or  
difficulties such as concrete paths or architectural feature impediments.  
While most if not all TIC outdoor speakers use and recommend burying  
the cable lightly 4-6 inches, if the cable is surface mounted you must  
make sure the cable is placed where it cannot be tripped over, pulled,  
abraded or crushed.  
3. Do not place your TIC outdoor speakers in a depression or area where  
water pools or in the direct path of sprinklers.  
4. Wherever possible avoid long term exposure of your new TIC outdoor  
speakers to chlorinated solvents, acids such as those often contained  
in fertilizers and other solvents which have the potential to eventually  
wear the components prematurely.  
5. When installing either burial cable or TIC’s in-ground outdoor speakers  
please be very aware of any submerged plumbing, piping such as  
sprinklers or irrigation and wiring already in existence.  
A note on Speaker Cable;  
TIC recommends the use of our SPC30, 50 or 100’ double insulated high  
quality speaker cable, however just about any reasonable speaker cable may  
be used including existing runs that may be in place. For standard 8  
installations of 10 – 25ft., just about any 16/18 gauge 2 core cables can usually  
be used although we would prefer a double insulated or burial spec cable be  
used. For longer runs of 25 – 100ft. 10/14 gauge cable can be used however  
resistance down the line will become a contributing factor.  
Please visit TIC Corporations website at www.ticcorp.com and review the  
Audio Installation Basics articles under Technical Resources for more in depth  
exterior audio and cable guidelines.  
 
Before actually sinking the cable, run the cable from your unit to the power  
source or amplifier. Ensure your cable run avoids any obstacles such as  
sunken sprinkler pipes or piping and electrical cable to your house. Once the  
cable runs are where you like them, connect your speakers and power source  
to ensure correct operation before sinking the cable. Disconnect the cable wire  
at both ends and continue.  
An Important note on Polarity!  
Pleasure proper polarity when connecting your new TIC outdoor speakers.  
This is very important and will result in poor sound reproduction and possibly  
equipment damage if not connected correctly. This is normally avoided by  
ensuring + to + and – to – or as sometimes color coded Red to Red and Black  
to Black from your amplified source to your speakers respectively.  
Once you have tested your cable run in step 3, it is time to sink the cable. 4-6”  
of cover is normally recommended to offset accidental disturbance, movement  
of the earth etc. but your specific onsite conditions will apply. Should you wish  
to secure the installation of your unit then simply clamp, by way of a “U” spike  
etc. the cable directly beneath the unit.  
Reconnect the speakers and your receiver amplifier being careful to ensure  
correct “Polarity” matching.  
 
Once connected properly, fill in all trenches, sit back and enjoy!  
Disclaimer;  
TIC Corporation will in no way be held responsible for the improper or  
unsecured installation of this product. Any and all damage arising from the  
installation or use of this product is the purchaser and final installer’s sole  
responsibility.  
Maintenance…  
Occasional maintenance of your TIC products cannot hurt and may help  
greatly. Inspect the installation area regularly removing and twigs, dirt or  
particulate matter from impeding or building up around the output grill area. The  
units may be cleaned using very mild detergents like dishwashing liquid if  
desired. A hose with clean water may also be used but please avoid using high  
pressure or forcing water into the grill or acoustic ports.  
In very cold climates with moderate to heavy snowfall an old trick from the  
major theme parks we supply world wide is to place a plastic bag over the unit  
for the winter or periods it may be not in use or under such snowfall.  
Customer Service…  
For any additional help please contact TIC Corporation at (800) SPX-OMNI, on  
line at www.ticcorp.com , or by email at [email protected] where we would be  
happy to assist you at any time. Also please visit our website for FAQ  
(frequently asked questions) and full contact information.  
Warranty Period…  
TIC Corporation offers a full, UCC approved, one year full parts and labor  
warranty on all its products as standard however there are other 3 and 5 year  
warranties in use with various TIC authorized Dealers world wide. Please check  
your enclosed Warranty card or your Dealer receipt to find out which one  
applies to you. Also please note TIC Corporation General Terms & Conditions  
posted on our website at www.ticcorp.com for further information.  
 
Installation Notes…  
1. The TIC GS10 Omni Speaker model requires no in-ground speaker or  
cable installation. This omni speaker unit is often used portably and is  
only permanently installed to the customer’s specification.  
2. The GS5L & GS7 models also provide a gentle 360° light using a low  
voltage 25W/ 12v, lamp. This also requires you to connect the low  
voltage lighting transformer.  
 
Trouble Shooting…  
Problem  
Please Check  
Check the speakers are connected to the cable  
correctly.  
No Sound  
Check the speaker cable is connected to the receiver  
amplifier correctly.  
Check the receiver amplifier is powered “on” at the  
mains, is not on “mute”, has no headphones attached  
and that the Channels used for the exterior speakers  
(usually A or B) is in operation.  
Refer to the owners guide that came with your  
receiver amplifier.  
Most initial problems are connectivity, please try a  
different connection cable to your outdoor speakers  
or equipment.  
Check the “balance” control on your receiver  
amplifier.  
Check all connections and cable to the inoperable  
speaker.  
No Sound from one  
speaker  
1. Disconnect the “working” speaker from the  
receiver amplifier connection/ channel. Switch the  
cord from the non-operating speaker from its current  
connection to the “working” speaker connection. If  
the speaker now works the problem is your receiver  
amplifier.  
2. Reconnect as original. Remove the speaker cable  
at the “working” speaker directly and connect it  
directly to the non-working speaker. If the speaker  
now works the problem is somewhere in the original  
speaker cable.  
3. If the speaker still does not work the problem is the  
speaker.  
One speaker sounds  
distorted, lower  
Follow same procedure as above for “No Sound”.  
volume or “different”  
Check the “tone” setting on your receiver amplifier.  
Adjust the Treble and Bass settings on your receiver  
amplifier.  
Treble or Bass  
Check the connections carefully from the amplifier to  
your speakers and ensure correct Phase (+ to + and  
– to – accordingly). Poor sound replication is  
expected from a speakers or speakers out of polarity  
or phase.  
 
General Specifications  
Outdoor Omni Speakers  
GS3, GS5, GS5L, GS7, GS10 Models  
Speaker Drivers 5” or 8” full range Co-Axial Drivers  
Injection molded PP cone with  
Woofer(s)  
Butyl rubber surround  
Tweeter 1" aluminum  
Cabinetry Impact resistant ABS  
Grill Anodized “sound assist”  
5”: 67Hz – 19kHz  
Frequency Response  
8”: 36Hz – 19kHz  
5”: 86db ± 3db  
Sensitivity @1W/1m  
8”: 89db  
5”: 50 / 100W  
Continuous/ Peak  
8”: 100 / 200W  
*Inches  
Unit Size  
Unit Wt.  
GS3  
12.5x12.5x12.5  
10 Lbs  
GS5  
8.8x8x8  
GS5L  
10x8x8  
GS7L  
13.5x12.5x12.5  
10.5 Lbs  
GS10  
13.7x6.5x6.5  
3 Lbs  
5.2 Lbs  
5.5 Lbs  
13x13x13  
12 Lbs  
10x17x9  
11.8 Lbs (2)  
10.5x17.5x9  
12 Lbs  
14x13x13  
13 Lbs  
12x14.5x7.5  
6.5 Lbs  
Pack Size  
Pack Wt.  
TIC Corporation engages in continual product research and development, new  
materials, production methods and design improvements. TIC Corporation therefore,  
reserves all rights to change or improve products specifications without notice.  
TIC Corporation  
15224 East Stafford Street  
City of Industry, CA. 91744-4418 U.S.A.  
Tel: (626) 968-0211 (5 lines) Fax: (626) 968-1363  
 

Technics CD Player sl mc410 User Manual
Texas Instruments Computer Drive TMS320F20x F24x DSP User Manual
Texas Instruments Stereo Receiver DEM DAI3793A User Manual
Thermos Gas Grill 4611118 User Manual
Toastmaster Oven 353 User Manual
Toshiba Projection Television 57HC85 User Manual
Tripp Lite Switch PAM 1 User Manual
Vintage Music Pedal TO800 User Manual
Vivitar Digital Camera Vivicam 3735 User Manual
Vulcan Hart Oven CB1824E User Manual